Simple and Economical

Have you ever looked at your existing windows and thought you would like them to be double glazed? You dismissed the idea because it would be too expensive and you didn't want to go through the construction mess of pulling out the windows. Well think again. Now it is possible to double glaze your windows at surprisingly affordable prices.

glazing01

A single pane of glass provides very poor insulation because glass is a good conductor of heat. Therefore much of the heat in the room literally goes out the window. Install double glazing and a layer of air is trapped between the panes. Air is a poor conductor so far less heat is lost through the window.

glazing02

For existing timber windows the single pane of glass is removed and replaced with a double glazed unit.

Double glazing cuts down on the cold draughts off windows and significantly improves the comfort level of a home. Another benefit of this double glazing is significant noise reduction. If noise is the major problem, laminated glass can be installed to further enhance the noise reduction properties of the window.

Timber Windows:

Double Glazing consists of two panels of glass set together with a spacer in between and sealed, trapping air inside. The air inside the unit greatly reduces the amount of hot or cold air that transfers from either side of the glass, thereby almost halving the amount of heat loss through the window. Argon gas can be introduced to give increased insulation.

Our double glazed units are constructed using the superior Super Spacer Warm Edge Technology. As there is no metal content in our insulated glass units, there is a higher insulation performance achieved compared to units constructed with an aluminium spacer bar.

Our Double glazing supplier is a Member of the Insulating Glass Unit Manufacturers Association of Australia.

Our high quality insulating glass units are primary and secondary sealed under controlled conditions in the factory.

If requested, an inert gas, such as argon, is used to fill the internal space between the glass panels to further improve the insulation.

The space between the glass panels is created by the inclusion of a hollow spacer bar at the perimeter. This spacer bar that is filled with a desiccant material is bonded to both glass panels.

Acting through a tiny perforations the desiccant will absorb and permanently lock away any residual water vapour resulting in only totally dry air within the sealed space between the glass panels. Trapped dry air is a very good insulator and internal condensation is not possible.

20120528154759948

Converting your timber windows:

The existing single glass panels are replaced on site with factory sealed Double Glazed Units.

Our skilled staff will convert your windows by:

  • Removing and discarding the old single pane glass
  • Modifying the existing window and/or door frames
  • Installing the new Double Glazed Units

We can also replace your entire window and replace with a new Double glazed Window

Aluminium Windows:

The existing aluminium windows is measured and a new Secondary Window is manufactured to specifications. The new Secondary window is then installed behine the original window frame, which is retained within the internal reveals adjecent to the existing window. Our Double Window System is a cost effective solution for existing windows. Compared with most other systems on the market this product provides superior noise insulation, particularly when using laminated glass.

The Double Window System is barley percepitable from the outside. Therefore it is the ideal solution for noise and thermal control in flats, units and other higher density dwellings where body corporates may have controls on the external aperance of buildings.

SetWidth250 window secondary

We can also replace your entire window and replace with a new Double glazed Window

Installation:

Installation usually take less than half an hour per window and without the inconvenience that is usually associated with a window replacement such as delays, lengthy site works, architrave removal/replacement, painting etc.

We offer the best possible price and installation service within Canberra, Sydney and Melbourne whether you are a homeowner, builder, tradesman or renovator. 

Call us now at 02 62805300 or 1300 932 202 send an e-mail at info@justrite.com.au and our seasoned consultants will guide you from evaluating your requirements, suggesting the most suitable replacement windows and/or doors to getting the replacements and installations done while leaving your property in a tidy condition.

Copyright © 2017 — Just-rite All Rights Reserved.